smic j pipe with fmic

[v8killerr1]

I'm in the middle of a xs power fmic install. I've got the smic j pipe and was wanting to know if it is possible to use this with the fmic? Can I hack the j pipe and put a 90' coupler and run the piping between the transmission mount and the fan? any help is greatly appreciated.

 

[daren_p]

It probably can be done but it will be a huge pain even if you can get it to work. Sounds like you have the jpipe that exits on the passenger side of the front torque mount. With the fans and everything its going to be hard to make work. I was origionally going to mod my RRE jpipe to work with my short route FMIC setup but descided it would be to difficult in the long run. I just got a jpipe from dejon tool, there's exits in the right location for a fmic setup towards the drivers side of the torque mount.

 

[v8killerr1]

I ordered the one from dejontool. The bad thing is I forgot all about that I needed the fmic j pipe until I was doing the intercooler piping. Right now the piping goes underneath the frame and is about 4-5 inches off the road. I don't think I really want to drive it like that.