Same 3.5 Bar MAP Sensor for AEM EMS and Zt-2 wideband??

[MG200]

Can I use the same 3.5 Bar MAP Sensor for AEM EMS and Zt-2 wideband?? Or does each unit need there own??? I already have a zt-2 with the sensor and am getting a ems so if I can save $135 on getting a 2nd sensor that would be sweet.

 

[MG200]

In case anyone was wondering, the zt-2 can read boost from a 3.5 bar MAP sensor.

 

[DSMJim]

Try the tuning forum, this is for discussion of bolt on parts, not tuning specific questions. You may get a better answer over there from guys running the AEM.

In my experience, sensors shouldn't be used to split readings to two different devices, but tell that to all us 2G guys with 1G motors that have a 1G cas emulating the 2G cas and 2g crank angle sensor ..