Need mount help.... please

[5150FWDLASER]

Ok so i own a 91 laser turbo... M/T,, my oem mounts were simply not good enough for my upgrades so i decided to get some after market mounts 4pc kit from drop engineering, bad thing is the back mount came up being to short (as in vertical hight) is this do to the kit being for a 1g awd not my fwd???

Any feed back would help so much, as in my car is taken apart and i need it for work tomorrow... thanks guys

 

[Doesnt start monthly]

Fwd or awd shouldn't matter. I would compare the specs of the custom ones verse the oem. I have a 96 awd and a 99 fwd and rear mount is the same.

 

[901gtsi]

The kit you have is for a 1g awd. Drop engineering dosent make a kit for a 1g fwd. Im pretty sure the only mount's that are the same on 1g fwd's and 1g awd's is the drivers side mount, (The one by the t-belt) and the front, trans, and rear mounts are completly different.

 

[5150FWDLASER]

Correct the only ones that fit right were the driver side and the passanger side mounts... the back (near firewall) is about an inch and a half short,
i tried bolting the rear mount on and then tryed to pry the engine back so it could sit (go over the mount) but no luck, the mount is to much to the driver side, and wont line up with the mount...
So thats why i was wondering if and AWD Bracket would be different.. because mine is the 194a mount