Just finished Porting!!!!

[jibberishballr]

Well i must say air tools are a lifesaver. Id post pics of the port job if i had a digital camera but since i dont ill just describe it. It looks nearly identical to the job done on the how to cure boost creep tech guide:
http://dsmtuners.com/forums/showthread.php?t=186525

The only difference on the turbine inlet is ours might be a littler wider...hehe
The wastegate flapper opens exactly 90 degrees and the turbin has a direct and smooth passage for the air to get to the wastegate. I also opened up the wastegate whole a little. All in all it looks good. I was happy with a successfull port for my first time!!!

 

[jibberishballr]

Trying to get my friend to come over with his digital camera...pix hopefully on the way!

If he doesnt get over here soon were gonna have to skip the pix and install this thing!!!!

Running out of daylight!!

 

[kenamond]

Trying to get my friend to come over with his digital camera...pix hopefully on the way!

If he doesnt get over here soon were gonna have to skip the pix and install this thing!!!!

Running out of daylight!!

Awesome!

Don't forget to prime your turbo before you start up the car so there is oil in the cartridge when you finally start it up. Disable the spark and fuel and crank it over 3x for 10 seconds each. Give your starter motor a bit to cool down between cranks.

 

[jibberishballr]

Awesome!

Don't forget to prime your turbo before you start up the car so there is oil in the cartridge when you finally start it up. Disable the spark and fuel and crank it over 3x for 10 seconds each. Give your starter motor a bit to cool down between cranks.

Thanks for the reminder. Hey i have a quick question. I plan on gettin an oil change the tomorrow but until then will i be alright to run the car with some 100% synthetic that my mom uses in her car. (its 10w30) I plan on having them put in mobil1 but will it hurt to run the other stuff for a day?