day 7 project alice

[tweakgod117]

motors out heads off found what i feared .. the kid who had it before blew #2 piston and just replaced that piston didnt macine the block and i have a 1/8th gouge in the cylinder wall all the bearings on the bottom end wer shot tapered on the front and rear main bearings down to the brass and the center bearings are just well smoked the rod bearings all look like he used sand for oil. the turbo is smoked . did i mention he had no coolant lines ran to it ! word of advice to newbies DONT BUY A DSM FROM A HONDA GUY

 

[DSMbabyy]

that was my first mistake right there. Good luck on the build!