Boost controller help

[miclo16]

all right i think i got a problem with my mbc this is how i have mine setup ive got a line going to the bov and than teed of to the top of wastegate, and than another line going to the bottom of the wastegate im pretty sure im missing something.
Is there supposed to be a line running down to turbo if so my turbo doesnt look like i have any thing i can connect it to, would i have to drill a hole in it ?
thanx for the help!

 

[9!'clipseDOHC]

Check out this site: Best way to install a MBC.

If you don't have a nipple on your j-pipe you would need to drill and add one.

 

[miclo16]

all right i found it but now i need the correct way to connect the mbc help please project so close to being done and also i painted the manifold with high heat and put a clear coat non high heat over it bad idea because now it is starting to smoke quite a bit from it thank you for help i appreciate it im just trying to get it ready for car show this saturday

 

[9!'clipseDOHC]

all right i found it but now i need the correct way to connect the mbc help please

That is the link I posted, the best way to hook it up. The vacuum line at the bottom of the MBC goes to the j-pipe/compressor and the line at the side of the MBC goes to the wastegate.

 

[Boosted_talon98]

That is the link I posted, the best way to hook it up. The vacuum line at the bottom of the MBC goes to the j-pipe/compressor and the line at the side of the MBC goes to the wastegate.

If its a small turbo you will get better response running it from intake manifold insteasd of compressor

 

[miclo16]

my mbc is a jdm mbc now the way the picture is it it set up right how those two line are going to the wategate and is the line that is being teed off does that go on to compressor. thanks again for the help just really want to get this thing to the car show this weekend

oh and by the way that is the same wastegate that i have too oh and i looked at the link but my mbc like i said before has that tee do i relly need it or i do need it cause it connects to the bottom of the wastegate and ive been told the line that gets connected to blowoff valve goes to the pc valvethat comes off the valve cover is that right? thanks again for the help

 

[9!'clipseDOHC]

The line from the BOV goes straight to the nipple on the intake manifold, not to the PCV valve on the valve cover.

Some people "T" their MBC into the BOV line (instead of going to the j-pipe/compressor housing) but this is not recommended. The best way is for the BOV and the MBC to each have there own boost sources. Another option as Boosted_Talon98 mentioned is to run your MBC to a port on the intake manifold/TB if you don't have a nipple on your j-pipe or compressor housing.

Also try using punctuation, it makes it easier for us to help you if we can understand what you are talking about.

Hope this helps!

 

[miclo16]

So is the picture right on setting the mbc up, and the line on the bottom right goes to the housing, and exactly which line does the bov connect to?