2g o2 housing on a 1g, oxygen sensor?

[Dream On]

I'm wanting to put on a 2g o2 sensor housing (ported) and my o2 sensor is bad from the code I got (code 11). Do I just get a new 1g o2 sensor or do I need to get a 2g one? Thanks.

 

[oldman]

Go with the 1g sensor, 2g front sensor comes with different plug and wire length. The only modification you will need to make is to drill a new hole on the heat shield as the sensor location is different on a 2g o2 hosing.

 

[Dream On]

Thanks oldman. I may start porting stuff soon, so be prepared to look it over.

 

[Dream On]

One more quick question, I'd like to port my turbine housing (14b) and my 2g manny and o2 housing. I hear that the gaskets in the exhaust should just be replaced with copper rtv, which is what I was going to use. But since I don't have the 7 cm gasket, I won't know how much to port. What should I do about this?

 

[oldman]

One more quick question, I'd like to port my turbine housing (14b) and my 2g manny and o2 housing. I hear that the gaskets in the exhaust should just be replaced with copper rtv, which is what I was going to use. But since I don't have the 7 cm gasket, I won't know how much to port. What should I do about this?

I have some paper cut outs from my previous porting projects, pm me your address, I'll send one of them to you.