I'm having an issue with adjusting the clutch pedal on my 1g. New Clutch, New pivot ball, New clutch arm, New OEM throw out bearing, fluid bled and triple checked for air.I'm following the video on youtube from Jacks Transmissions. I am adjusting to find the point where the slave stops being...

I replaced my master and slave cylinder about two weeks ago. I had the same issue at first after installation. The car would shift when the vehicle was off and I could start it and drive in a gear but when the car was running I couldn’t shift out of the gear I was in nor could I shift into any...

I'm about to replace my master cylinder because the seal that goes through the firewall leaks a lil. I know how to put it in I just need a little guidance on how to bleed it after replacing it. A step by step or video would be very helpful -thanks

Newbie here, ordering parts but they only have cylinders for GSX. I own a 97 GST. Are they the same? I would assume so since the only difference between the two is FWD & AWD, but just wanted to be sure. Thanks!

New gates master and slave. Watched jafro and jacks videos. Tried an extended and oem slave rod. No leaks. pivot ball not shimmed Unsure of flywheel step height. Everything seemed fine til I put this used braided hose on. After a few miles of in town driving I lose my clutch at a stop. Won't let...

My master cylinder and my slave cylinder are both leaking fluid which leaves it dry after every time I drive it. I am going to replace both of them as soon as the parts come in. All I need to know is do I have to pull the engine or trans to do this? Or any other major components that would take...

I've got a couple parts laying around that someone may be able to make use of so I figured I'd post them up.98 gst starter, was is working condition but I was doing everything new so I replaced it. - $30 + shipping2g shift manual shift linkage. I swapped mine out for a new one when I was...