Need guidance on installing head light strobe

[95eclipse223]

I just got these set of head light strobes from EUROLITE and was wondering what would be the best way to install them. They are not the ones that you would drill a hole in the back of your head light housing. Just wondering on how to install. Please help me.

 

[twack]

would it also be possible since i took out my fog lights but i still have the plugs that ran to them is it possible to run strobes off this then all i got to do is hit the fog switch and i got strobes. any help would be great

 

[sk8shorty01]

just remove the wires in the fog lights and put the strobes in the hole in the back where you would normally place the bulb for the fog light. Then use the wiring that came with the strobes to run the power and ground. You can use the wire that runs up to the switch if you want to save time but if you are going to do that please use connectors and electrical tape, dont just rig it in there or you will be fixing it all the time. You can ground it out using the fog light wiring as well if you want but its just as easy to run your own and just remove the one that is there for the fog lights. Just find a nearby body bolt and loosen it, put the connector around the threads, and put the bolt back in. Either way will work so its all up to you. Just remember to use connectors, dont take short cuts there or you could short something out later on and really regret saving those whole two minutes.

 

[twack]

wont take shortcuts but no matter what i do i cant get any power to the fog light plug, whats fuse is it. if thats not it i might just have to run it

 

[sk8shorty01]

The fog light power fuse should be under the dash near your "clutch" foot. There is a map on the case so read it and see if you can find anything that says something about the fog lights. If not then just run the new wire like you were saying, but make sure you also secure the wire (and hide it). Run it inside the factory harness, or make a new section of the harness, so that later on down the road the car still looks perfect and clean. You can pick up a manual from advanced auto or autozone on your specific car, and year, and this will show you wiring schematics, and also the fuse locations. This should help you locate everything.