jeepman1998
10+ Year Contributor
- 48
- 0
- Feb 13, 2011
-
ravenna,
Ohio
Well since my intercooler hung down past my front bumper I decided to cut it in half
and drop the bottom down 2" for more flow to intercooler and cause I was bored.
bumper is getting ready for plastic dip and will be done this weekend but here is a shot of about halfway through the process. I used perferated stainless sheet metal and screwed it together then fiberglassed it. had my buddy shave the emblem and start with bondo. I made the center pieces wider to match because they looked too skinny.
when I get car dipped will post a build thread. Kept my car on down low for a while while I planned it and got all parts ready
and drop the bottom down 2" for more flow to intercooler and cause I was bored.
bumper is getting ready for plastic dip and will be done this weekend but here is a shot of about halfway through the process. I used perferated stainless sheet metal and screwed it together then fiberglassed it. had my buddy shave the emblem and start with bondo. I made the center pieces wider to match because they looked too skinny.
You must be logged in to view this image or video.
when I get car dipped will post a build thread. Kept my car on down low for a while while I planned it and got all parts ready
