A80Avant
Probationary Member
- 18
- 0
- May 31, 2009
-
UK,
Europe
Hello all,
im planning to use a Holset HXSuper40 in my audi RS2 (5cyl engine).
i have most parts gathered up, and trying to make sure that the turbo will work properly.
i read on the holset forums, which i cannot post at, about oil specific psi needed to work properly.
the Audi has about 73psi on load and cold start and maintains about 28-30psi on warm idle.
When i bought the 0.70AR hotside from bullseye, i got them to send me the oil feed seen on the photo
CIMG0914.jpg picture by vasp3690 - Photobucket
would that be adequate for the turbo? or will it be too much of a restriction?
http://s117.photobucket.com/albums/o59/vasp3690/?action=view¤t=130720091122.jpg
im planning to use a Holset HXSuper40 in my audi RS2 (5cyl engine).
i have most parts gathered up, and trying to make sure that the turbo will work properly.
i read on the holset forums, which i cannot post at, about oil specific psi needed to work properly.
the Audi has about 73psi on load and cold start and maintains about 28-30psi on warm idle.
When i bought the 0.70AR hotside from bullseye, i got them to send me the oil feed seen on the photo
CIMG0914.jpg picture by vasp3690 - Photobucket
would that be adequate for the turbo? or will it be too much of a restriction?
http://s117.photobucket.com/albums/o59/vasp3690/?action=view¤t=130720091122.jpg
