red_devil
15+ Year Contributor
- 1,380
- 96
- Jul 13, 2005
-
Richmond,
Virginia
A dreaded fuel sending unit fitting question
well I was trying to remove my fuel sending unit hose to install my STM tank to rail kit. And man is this thing tight. Sprayed it for a day with blaster, I used line wrenches and made sure not to bend the line and brake it. Well the damn thing is so tight that the line twisted. I removed the whole thing and thought about drying it off and adding heat but it's so twisted now that it will reduce flow.
I've seen people install a AN fittings inside the unit and was wondering what to use and how?
Or could I cut the line and weld a AN fitting on the pipe?
well I was trying to remove my fuel sending unit hose to install my STM tank to rail kit. And man is this thing tight. Sprayed it for a day with blaster, I used line wrenches and made sure not to bend the line and brake it. Well the damn thing is so tight that the line twisted. I removed the whole thing and thought about drying it off and adding heat but it's so twisted now that it will reduce flow.
I've seen people install a AN fittings inside the unit and was wondering what to use and how?
Or could I cut the line and weld a AN fitting on the pipe?
Attachments
Last edited by a moderator: