Hello, So I guess my plugs fouled and are throwing a P0300 code. Initially I was using Bosch Iridium Plugs but I guess that ain't the move. What plugs should I run on my 420A non-turbo? If also possible, part numbers?Also I did see from the owners manual that it recommends I run with Champions...

So, I pulled the car out of storage after many years, set up ECM link, and decided that even though the timing belt had been replaced less than 10k miles ago, it had been ten years and was advised to replace it. I have everything off and installed the new water pump, reinstalled the radiator and...

Hi does anyone know how to remove ECT sensor pins, one of my pin wires got snagged and ripped off. :(I’m trying to just reattach new wire to it and just connect it.You must be registered to see element.You must be registered to see element.You must be registered to see element.

Does this come off towards me or away . I’ve done this before and I totally forgot and it’s giving me a hard ass time. And it’s slowly rounding off.You must be registered to see element.

I have a 1995 gst that I recently did a head gasket replacement and belt refresh on right after I bought the car. I have battling this squeal for awhile now, and need some help with the next step or any information to diagnose. I know this is probably the 10 thousandth question about a belt...

For those that are not familiar with the general upkeep and service of automatic transmission's, John, at IPT Transmission, has You must be registered to see element. for you:You must be registered to see element.Thanks John.

Hi, I have had these problems for some time now, the engine is rectified, it is a 420a from 1995 The revolutions are always around 2000 revolutions without me stepping on the accelerator or anything, and in my head it makes the sound of the hydraulic lifters but they are new, I have tried...

Hey Everyone, Long time no see! I havn't touched my poor 97 Talon TSi in 3 years and i finally got the cash to rebuild my head so I'm seeking some advice after I've read through a couple of the forums here.Background Story: A few years ago my valves smacked my pistons so i had the head...