Will a Evo III O2 housing gasket work with a 2g ported O2 housing?

[Generation X]

Just as the title states guys.

Do any of you know if I would run into any problems running one on my 2g RRE ported O2 housing? Thanks for any help!!

 

[sd_ff22]

thats what I run.
works fine so long as your gasket does not interfere with flow. this will only happen with a bad port though.
I ported my 14b and my 2g o2 housings to match and be just barely smaller than the evo gasket. that way if the gasket expands from heat, it will not interfere with the exhaust flow.
good luck!

 

[Generation X]

thats what I run.
works fine so long as your gasket does not interfere with flow. this will only happen with a bad port though.
I ported my 14b and my 2g o2 housings to match and be just barely smaller than the evo gasket. that way if the gasket expands from heat, it will not interfere with the exhaust flow.
good luck!

Yeah that 's what I've actually been doing. I've been running a stock 2g O2 gasket with a ported RRE ported O2 housing and I've always had that little lip from the gasket port holes not being big enough, so therefore I think mines hindering exhaust flow a tad. I think I'm going to purchase a Evo III gasket. Thanks for your help.

 

[sd_ff22]

the one i got was stainless and laser cut. it was very nice!
good luck!