Were can I get a bigger throttle body elbow?

[ktowntalon]

I made a custom UIP but I don't have a larger throttle body elbo. That is were the pipe always pops off. Does anyone know were i could buy one or any easy ideas to make one?
thanks
ktowntalon

 

[boosted_91_tsi]

Look for a 2G elbow, they are slightly larger then the stock 1G.

 

[Xeiros]

I would look on ebay personally. I've seen some for a 2G that were as large as 3".

 

[rst95eclipse]

If you have a welder, a drill with metal hole saw bits, and some time, you can fabricate one yourself and bolt it directly to the throttle body. I would use the metal/mesh gasket material to seal it off.

 

[LordZed]

You could cut your current one down, but you will need to have the IC pipe match up accordingly. It's what I just did with mine.

 

[RamenPride]

I got mine from Dave Brode, the guy whose better known for his UICP's. Don't remember how much it was, though. It's 2.5" in diameter

 

[freshfabiotsi]

an exhaust shop can help you out just give them the flange and then get a coupler with clamps and you'll be good.