magnus hondata intake gasket questions

[AL92]

I bought a magnus plastic type intake gasket .Think its actually a hondata gasket.Do I just put in or is there anything else i need to do. Thought someone said copper spray on it is a good thing. Can't see why though its plastic or something.

 

[yangtech]

when i install my i didn't put anything on it.

 

[staticbrainwash]

Did you notice a big difference after you installed it?

 

[GstRacer]

the only thing i really noticed is the my magnus intake minifold was not as hot to the touch but as for power gains so small if any that i couldnt tell

 

[staticbrainwash]

So not really worth it for the hastle of pulling off an intake manny just for the gasket?

 

[GstRacer]

well i think it is worth it becasue and cooler air always gives more power but i would wait till you need to pull it off because the stock intake mani is a bi*** to get off. there is a bracket in the back the hold the intake mani up and it conects to the block thats a pain to get off unless you have a lift

 

[yangtech]

i only put the gasket on because i needed to replace it when i pull the engine out. i would wait until you need to replace that gasket than buy one and put it on.

 

[jott5555]

honstly pullin the stock mani is really easy to remove.. you can get the bolts from under really easy.

 

[CanadianTSi]

Anyone know when the 2G Gasket is coming out??

Marco said it would be out anyday like 4 months ago...