OB1
20+ Year Contributor
- 89
- 0
- Dec 1, 2002
-
Ottawa,
I just picked one of these up, installed it and have a few questions. I am running a tial external gate.
1) I would like to confirm that the middle port (port #3) is the line that goes to the wastegate trigger nipple.
2) If your wastegate only has one nipple like my tial, port#2, the line running to the compressor nipple does not have to be t-d to a secondary wastegate nipple and can just be ran directly to the compressor?
3) What does your boost read at idle? Mine reads -0.48 bar which to me is too low. My boost guage reads (-15psi) so just a little over - 1 bar.
I have downloaded the installation manual and installed everything as best I could understand, attempted to dial everything in, but I keep getting unlimited boost whether the boost controller is on or off.
1) I would like to confirm that the middle port (port #3) is the line that goes to the wastegate trigger nipple.
2) If your wastegate only has one nipple like my tial, port#2, the line running to the compressor nipple does not have to be t-d to a secondary wastegate nipple and can just be ran directly to the compressor?
3) What does your boost read at idle? Mine reads -0.48 bar which to me is too low. My boost guage reads (-15psi) so just a little over - 1 bar.
I have downloaded the installation manual and installed everything as best I could understand, attempted to dial everything in, but I keep getting unlimited boost whether the boost controller is on or off.
