I bought 1/8 line for my aeromotive fpr from the stock location and 5/16 for the bov from stock location. Does that seem right? And instead of a tee off of a different line, I took the allen cap out of the intake by the EGR plate and want to use a 3/8 npt to 3/8 barb for a MAP. Will that work if...

I have the Hayes manual on the way but I'm impatient and haven't found a thread with it yet. I am putting back together a car that was half assed and some of the vac lines were just left loose I don't know where they go 😂

Hey Everyone, Vehicle is 1990 Eagle Talon Tsi AWD. Pretty sure its Federal as well.So I have seen multiple diagrams of how the 1g DSM vacuum lines should be, I guess I just wanted to confirm if this setup makes any sense. I'm assuming the solenoid all the way to the right is the fuel...

just trying to research necessary vacuum line sizes when using -AN fittings. I’m running two Tial waste gates and Tial BOV with JMF race intake, Omni MAP, FPR, brake booster, etc. I want to keep the aesthetics of the build so I want to go with -AN hose fittings and hose, but having sleepless...

Some of the vacuum hoses on my Talon are looking a bit worse for wear and it would probably be a good idea to replace them. I got a loaner vacuum test kit from Autozone that I intend to use to see if there are any leaks, plus I got a stethoscope to double check everything. But even if it all...