I have a -6AN stainless steel braided line and hose ends from an aborted project. I was thinking I could use it to replace the stock line from the filter to the fuel rail. Does anybody know what size the thread for the top banjo bolt is and/or where I can get just the fitting? I know that some places sell a kit for this type of thing, but I can't seem to find just the adapter for whatever size fitting that is to -6AN.

I stock all of the AN fittings. You just have to find out what the thread size is and I'll see what I can do.

well, I searched (which is what I probably should have done first) and it's 12x1.25

Scroll down toward the bottom of this page; it's called "-6AN Fuel Filter Outlet Adaptor":

http://www.automotosports.com/diy_misc.asp

I used the earl fitting...its a 6AN to 12mm x 1.25

http://store.summitracing.com/default.asp?target=esearch.asp&N=110&Ntk=KeywordSearch&Ntt=12mm+X+1.25

For the jegs link, bottom of the page.

http://www.jegs.com/cgi-bin/ncommerce3/ProductDisplay?prrfnbr=191808&prmenbr=361

EAR-991945ERL
It's only $6.95 on Summit.

That's probably the best one to use......

Mine is actually from Goodridge but I don't remember the part number. Works great, though.