Clutch replaced and now no power

[DearDoger]

HELLPPPPPPPPP I replaced my clutch got everything put back together. I went to start it up and I got no power at all not to the dash or anything I checked the battery, all the fuses, the grounds. I dont know what else it could be please any ideas or suggestions would help.

 

[Mr Peepers]

Clean the battery terminals/posts with a wire brush. DSM's seem to be really picky about this.

 

[-TunedDSM-]

As Mr Peepers said, clean the posts and terminals with a wire brush and make sure they are tight. The only other thing I can think of is the battery drained while you had it out, check to see that it has a full charge.

 

[DearDoger]

I spit shined it. still nothing

 

[DearDoger]

The battery has a full charge the one thing i noticed was the ground cables were somewhat fraid but not too bad I cant figure why im not even gettin power to the dash

 

[Mr Peepers]

If you followed a guide, look back through it and check over everything you touched. I can't think of anything besides the battery, fuse box and grounds. Starter perhaps, but that wouldn't affect the dash lights.

 

[DearDoger]

I removed all the componets of the air conditioner in the engine bay while i was in there could it have anything to do with that

 

[tunethis]

You may need to replaced the ground wire you were speaking of. Check your grounds again and all related connections you removed during the clutch install.

 

[DearDoger]

Thanks for all your ideas please keep them coming i need this dsm to get me to work. What could be the worst possible reason for this problem.

 

[92awddsm]

Check and make sure all connections at the battery are attached and nothing left unhooked(wires going to fuse box). Also check the ground cable attached to mounting bolt of starter.