2g pistons 1g big rods in a 6bolt

[Coder24]

keep in mind it is a stock head with a 3 angle valve job.
I have 2g pistons(std) and 1g rods Already machined ready to be pressed. After I get this altogether and ready to go is there ANYTHING that I should be worried about? I have an S-AFC to tune my fuel and a Palm-logger. Will my knock me outrageous? or anything else? Thanks in advance for your help.

 

[turbodsm_125]

you shouldn't have any problems with knock. make sure you don't tune your fuel to rich or lean. with the higher comperssion it may mess with your current fuel settings. but this is a poular mod and i have never heard of a lot of problems with it. just watch your fuel. make sure you run high octane fuel also so you avoid early detanation , which casue the knok senor to flip out.