Output shaft retainer bearings

[dawgedeclipse]

There is supposed to be either 1 or 2 small ball bearings that hold the center shaft in the center diff to keep it from moving in and out, I HAVE NONE!?
Do any of you know the size of these little puppies?
Are if they are orderable thru Mitsubishi?

 

[redX90]

I just had the same problem. I spent two hours at parts stores, on a Saturday of course, looking for ball bearings. Notta. I finally went to a good hardware store, Orchard Supply and Hardware, and picked up a pack of 1/4" balls. They were in a special section that just carried weard fasteners. One is all you need. It is just slightly bigger that the 7mm that was in there but will work just fine.