W5M33 Transmission: Is this all the parts I need for rebuild? HELP!

[DSMRevolution]

I am just going to have a local shop rebuild my transmission for me out of my 93 Eagle Talon TSi AWD. I am trying to put together a parts list so I can order the parts from Conicelli. I called them, but they really didn't want to help me over the phone. I hope somebody here can help me! Here is my list so far...

Bearings and Seals - Is there only 4 seals and 4 bearings total that need to be replaced? Is there a name for these so I can order them?

Keys and Springs - I have no idea what these are for, but what will I want to tell Conicelli I need? How many are there? Where do they go?

EVO shift forks - They know what these are.

Double synchro 2nd - Is this what I tell them I want? Anything else that goes along with this?

1,3-5 gear synchros - They should know.

2x36mm stake nuts - Is this all I say I need? Are these required?

Axle Seals - They should know.

Shift fork pins - Required I am assuming?

VC Snap ring - What is this?

Intermediate + input shaft snap rings - I need these too correct?

2g oil screener - This is the screener that will work right?

90-91 short oil guide - Do I need this?

Spacer for Intermediate + input shaft bearings - Will Conicelli Know?



Will this be everything that I need for the rebuild? I am kind of lost right now as to what I need. Anything else that you would recommend? Thank you very much.

 

[josh long]

You need to know the specific sizes for the shims/ clips and will not know what sizes you need until you are reassembleing the tranny. look here for detailed instrucion http://vfaq.com

 

[DSMRevolution]

Thanks for the reply. I have checked out Vfaq.com many times and have not found any information on what parts to order. It doesn't list it in their part rebuild section. Thanks though! Hopefully the place I am getting it rebuilt at will find out. Oh, and what do you mean by clips?

 

[josh long]

the circlips are used to shim/ stay the first second and third fourth gear shafts aka input and intermediate shafts. look here for another very good tranny rebuild site.

http://www.twingles.com/ideck/rebuild3/dretranny.htm

this may give you a better idea of what is going to happen.

josh

 

[DSMRevolution]

Yeah I saw that site. It really doesn't give me any information regarding parts needed to rebuild. Thanks for all your help though!