The Central Hub for DSM Community and Information

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. This is where the DSM platform history is documented and archived. Log in to help us in our mission, and to remove most ads from the browsing experience.

Post a Question

rear differential

  1. 2G DSM AWD D.S.S. 3.5" Aluminum Drive Shaft For Sale
    Sold

    For sale 2g 2G DSM AWD D.S.S. 3.5" Aluminum Drive Shaft For Sale

    Once again I am having to sell of parts that I bought for my GSX build because I have gotten into a really bad financial situation. This ad is for selling my Drive Shaft Shop 3.5" Aluminum Driveshaft with the standard 25 spline yoke. This driveshaft only weighs 17lbs and is good for 950hp. It...
    $825.00
    • LSM
    • Classified ad
    • 25 spline yoke aluminum carrier bearing carrier bushing drive shaft driveshaft driveshaft shop drivetrain rear differential yoke
    • Discussion: 1
    • Category: DSM Parts Classifieds

  2. Resolved Circular spring popped out with axle seal on rear diff

    while prying out rear differential seal a spring popped out, I was wondering where it goes cause I can’t seem to locate it on the other side… I looked on the graph as well and there seemed to be multiple springs in the rear diff? Not sure. Where does this go?You must be registered to see element.
  3. Closed

    Wanted Wtb 1g 4 bolt rear diff, axles and cups (manual)

    Looking for a 1g 4 bolt rear diff setup from a manual transmission car.I would also be interested in a 4 bolt diff alone as well.Thanks.
  4. XC92

    1G Did I just destroy my rear diff?!?

    So I was trying to install a new pinion seal on the rear diff of my '92 AWD Talon, and I used wrong-sized seal installation ring that had too narrow an inner opening (actually a part from my bearing installation kit), and after it drove the seal part of the way in, instead of contacting the...
  5. XC92

    Questions about rear AWD suspension & drivetrain overhaul

    I've been prepping for an overhaul of the rear end on my '92 Talon TSi AWD that I'm hoping to complete this spring, that I started a year and a half ago, it. On my first pass I removed as much rust and crud as I could from the control and trailing arms and painted them, with everything but the...
    • XC92
    • Thread
    • 1g dsm control arms crossmember rear differential rear suspension suspension trailing arms
    • Replies: 8
    • Forum: Handling Tech
  6. 1997 Mitsubishi 3000GT VR4 Rear Differential
    Sold

    For sale 1997 Mitsubishi 3000GT VR4 Rear Differential

    This unit was pulled from my 97 3000GT VR4 (a 6 speed) about 10 years ago with about 80-85k miles on it. I converted to MR Gearing and replaced this with a 5Speed rear-end. Includes the All Wheel Steering pumpAsking $500 plus shipping which will be ~$120 (unit is 70.1 lb. plus the crate I'...
    $615.00
  7. talonlan3

    1G Rear diff pinion shim

    I have a few questions regarding shimming my rear differential pinion gear. I am currently rebuilding a 4 bolt rear diff and I have .015” backlash. Looking for maybe some reference on how much shim to add to the pinion.Also curios if this is a safe website to order a shim pack from? You must...
Boosted Fabrication
ECM Tuning
ExtremePSI
FIBA Motorsport
Fuel Injector Clinic
Innovation Products
Jacks Transmissions
JNZ Tuning
Kiggly Racing
Morrison Fabrications
Rix Racing
RockAuto
STM Tuned
Support Vendors who Support the DSM Community
Back
Top