The Central Hub for DSM Community and Information

For 1990-1999 Mitsubishi Eclipse, Eagle Talon, Plymouth Laser, and Galant VR-4 Owners. This is where the DSM platform history is documented and archived. Log in to help us in our mission, and to remove most ads from the browsing experience.

Post a Question

piston rings

  1. VT_4G63

    Oil line Left Behind on Cylinder Wall When Turning Motor Over by Hand. What’s Causing This?

    Prior to installing the cylinder head on my short block after doing a refresh with some upgrades on it, I coated the cylinder walls with a bit of oil to keep them from rusting as I am not sure how long the engine is going to have to sit before i end up using it.When I did so and turned the...
  2. LSM

    2G Question about pistons

    So I have some Eagle Rods and Manley Pistons that were in my car when I bought it, but I have already bought new pistons and rods to do a 2.3L stroker. Iwas going to sell the rods and pistons that I pulled out of the block because they have very few miles on them! I wanted to clean them up a...
  3. Anfurnyy

    Resolved 1G - Another Ring end gap post.

    Sorry for making another one of these posts but ive searched for hours now with no real answer as most peoples setups are different and require different gaps.My setup is: 2.0L bored .020 over. Manley 9:1 piston w/skirt coating Shooting for around 700+wheel and 40+psi on e85. I will also run...
Boosted Fabrication
ECM Tuning
ExtremePSI
FIBA Motorsport
Fuel Injector Clinic
Innovation Products
Jacks Transmissions
JNZ Tuning
Kiggly Racing
Morrison Fabrications
Rix Racing
RockAuto
STM Tuned
Support Vendors who Support the DSM Community
Back
Top