hey i've finally put the motor and trans back in my car but there's some wires on the back of the motor and I don't know where they go. Could someone please give me a picture of how its supposed to look, thank you in advance.
Hello, I posted a few days ago about a reliable brand for an engine coolant temperature sensor and received a lot of help, so I'm back with more problems that I hope you can help me with.The vehicle is a 92' Galant with a 6-bolt 4g63 and an automatic transmission. As far as I understand it the...
Speed density harness $40+ship (2g to GM ait&AEM map- NOT for OMNI sensors although I have an Omni pigtail I can send free of charge.)
SOLD- Flex fuel harness-NEW(plugs into the SD harness)
6bolt in a 2g harness $50+ship
FIC hi-z injector harness adapters $30+ship
FIC resistor delete plug...
I'm going to show you how to hard-wire your SD kit and Flex Fuel sensors instead of using an adapter harness for those either redoing their engine harness or you simply don't have the funds for the adapter harness.There was very little information on MAF wiring that I could find but maybe I...
I am taking my 4g37 engine from a 1990 Laser and replacing it with a 4g63 n/t 6-bolt motor from a 1992 Talon. The '90 Laser has no A/C, cruise, etc. The Talon does. I already took both engines out and noticed that some of the connectors dont match up, i.e. the O2 sensor. I figured I might as...
I have the dash out. I want to remove the interior harness the one that runs to fuseblocks and such. I can't figure out how. I see the posts about wire tucking and such but not a guide for this. Could someone please help?