garrett center section turbine housing fittment

2blue4uRS · 01-25-2007, 05:11 PM

I'm trying to find/figure out a Mitsu style turbine housing that bolts up to a garrett center section. i have a T3/T4 57 trim with the ford 5 bolt housing and I want to replace it with a Mitsu style one that will work with the center section so I can just bolt it up and swap it out. Anyone know? Where I can find one?

maperformance · 01-25-2007, 05:41 PM

I believe Precision Turbo and Engine makes a .63 A/R mitsubishi turbine housing for Garret center sections, I can get you pricing if you would like. Let me know!

Thanks!

Chris

prostreetdsmx1 · 01-25-2007, 07:29 PM

Both precision turbo and bullseye make turbine housings that will meet your needs.

PTE uses a larger (.63A/R) cast iron housing and Bullseye Power has a casted Stainless Steel that is polished and looks awesome but is a .55A/R. That is not necessarily a bad thing. You will see a little more response and quicker spool but the PTE can make a hair more on the top side.

Can't really go wrong either way bud.

best of luck.

Boosted98gsx · 01-25-2007, 07:45 PM

Is anyone planning on (or is it possible to) make an ~80A/R housing?

2blue4uRS · 01-25-2007, 07:47 PM

good deal, thx guys, will look into these.

2gAWDTalon · 01-25-2007, 08:10 PM

Why dont you look into a T3 manifold? You are going to loose alot of top end with the small mitsu bolt on housings.

2blue4uRS · 01-26-2007, 07:28 PM

I trying to spend as least as possible.