HELP! Bullseye Exhaust Housing Sizing

[spendone]

I know this topic is killed to death but I am still confused on what will actually on. I have a HX40 and what can I check to see if the bullseye housing fits. Like I said its a HX40 with 8 compressor blades on the inlet. On the exhaust housing its held on to the center section by 4 bolts. Theres no tag on it so no numbers are available. It does have the Map Enhancement Grooves on the intake side though.

 

[project_tsi]

The best thing that you could do is to call up Bullseye in the morning. Since they make they turbine housings and HX turbo's, Im sure they will help you w/ ease. I have been to the Bullseye building and was treated w/ respect and they were very helpful. Call and ask to talk to Dan, or David, whoever is available. A lot of the times, a girl will answer phone, and Ive seen her, and she is hot!, Like it matters, but just an FYI.

Ask for Dan or David, and they will be very helpful.

 

[spendone]

In that case forget Dan or David, i want to talk to the girl. Hahahha, yea Ill have to probably just call my buddy thats a bullseye dealer and see whats up. Thanks for the info though.

 

[99gst_racer]

A lot of the times, a girl will answer phone, and Ive seen her, and she is hot!

HAHA. Yeah, that's Dan's wife.

 

[spendone]

I spoke with Dan today. Just if anyone needed to search this info in the future. All HX40's will fit the Bullseye Exhaust Housing.

 

[spendone]

I also was able to get my HX50 to fit the HX40 Turbine housing witha little machining work too. Dan did mention that you would have to have a huge exhaust and wastegate to relieve all teh back pressure.