im a dumbass

greentat · 10-16-2005, 05:45 PM

well i installed my safc2 buti didnt have the safc2 harness plugged to the unit i went inside to get the operating manual but i came outside and found out my brother had already started the car before i could set it up and is was running like shit, well it can still crank and run but it studders when i press the gas does anyone know what happend

NOMIEZVR4 · 10-16-2005, 05:56 PM

check your settings on the s-afc II..put all of them to 0..i would just take off the negative terminal on the battery for about a min to reset the ecu than i would start the car bck up

JiggahMan · 10-16-2005, 06:02 PM

Also, make sure the sensor type is on KARMAN.

greentat · 10-17-2005, 05:04 PM

i did that it still ran ruff yesterday and today it wont even start but it sounds like it wonts to

92GSXBaltimore · 10-17-2005, 09:25 PM

sounds like a wire isnt connected properly, but first make sure you set the afc to karman, and make sure the acc arrow points up.

oldman · 10-18-2005, 12:09 AM

Is your profile updated? If so, what is the purpose of the safc? I suggest removing it and see what happens.