I have searched and all their fixes have not worked.

My old cable I thought might have gone bad. I could not read any ohms on the 10k ohm resistor and so I decided to copy it and make a new one. Plus I think the resistor was to small.

All I get when I do a test is ecu comm error. I have checked to see if my ecu has a heart beat and it does. My logger worked and then it didnt I never unplugged it or anything. Running a palm IIIc.

I reset mmcd back to default and nothing.

Checked all connections and nothing.

So here is a pic of my cable I just made that didnt work, can anyone tell me if I did something wrong.

here is a new pic how does this one look.

I dont have all the pins in the connector. Just the three that the logger cable uses. Would this be the reason why I get an ecu comm error.

Help me please. My new motor will be in next week and I would really like to have a logger.

danyz250f said:

here is a new pic how does this one look.

Click to expand...

YOu still working on your wire. Well the diode is on the wrong pin. The diode is suppose to be in the middle.