Today was a nice day so I decided to try and throw on the side skirts I bought from dsmtrader. They are the 2ga Talon Turbo skirts.

First thing I noticed was I didn't have any holes or clip holders on my car so I had to install it quite crappy but it didn't turn out too bad. One side the tape already started falling off (have to fix that in the morning before school, its raining now )... and you can still see the 2 sided tape from up close. I'll get it professionaly installed (and shaved) later on after I get my bike, for now it'll do.

Nice

skirts are nice,
wheel gap??
thats needs some work quick

Thanks guys, yea that wheel gap is 3 inches I haven't had the money to fill it with a bigger tire. I spent it all on the motor and my new GSX-R bike

side skirts
wheel gap

looks good though

I also have skirts ready to go on. how did you mount it? with 2 sided tape?

I'm very skeptical about going that route in fear it will fall off during driving, any opinions?

Don't use 2 sided tape ! mine just fell of this morning! haha. I woke up and one side was sitting on the ground.

Get at least a couple screws to hold it from the bottom, im about to do that. I have to buy a better drill though because mine is a piece.

Looks awesome, although the part on the door doesn't really flow, needs some 2ga talon door skirts(sounded good to me). However I am in just the opposite position and need the kind you have for my 97 conversion, but looks very nice.

bah! the "no door cap " look is much more pimp

i dont know...i kind of like my door caps being on there

Ah Ha, "door cap" couldn't remember what it's rightful name was. However I'd say most look better with they right ones on it, but again he did a good job on the side skirts so it doesn't really matter.

it's messy, but a little better.

sooo.. whats the secret of mounting them without clips !?!?

my skirts are in the garage being prepped as we speak