i need help with my aem ems

[donaldseclipse]

i am just about ready to get my car started i have done a ton of swaps, all at the same time and for now i just need to get my 2g eclipse gst/gsx running (to know if the 6bolt swap works and my awd swap system works). i have the intermediate axle shaft bolt stuck in the outside of the engine so im only running three wheels and this is why i just need to get the car started to make sure everything is working then pull engine out (get the bolt out) then put it all back together. but i know nothing about this new aem ems

 

[donaldseclipse]

i had a wire from inside car that wasnt hooked up to starter but i stil cant figure out how to fire up my car with the aem everything is getting 12volts but i havent checked spark plugs coil or wires so thats next

 

[gofer]

why don't you just try starting it with the stock ECU?

 

[donaldseclipse]

car now runs fine with the stock ecu probley a little rich. im just gonna let the professionals tune and work with the standalone, but i did run into a problem with my awd drive shaft brackets. they were not correctly welded on so im just running fwd for now, im thinking about getting the aluminum two piece that way i eliminate the first mount.

 

[CFeclipse]

car now runs fine with the stock ecu probley a little rich. im just gonna let the professionals tune and work with the standalone, but i did run into a problem with my awd drive shaft brackets. they were not correctly welded on so im just running fwd for now, im thinking about getting the aluminum two piece that way i eliminate the first mount.

if u want to sell ## AEM EMS let me know =D i need one...