Friggin' transfer case problems!

[awd4g63]

Alright, I was going to change my transfer case today, and I got everything up and apart; all up to where you take the tcase off. I went to pull on it, and it would not come off no matter how hard I pulled. I even tried taking out the driver's axle assembly to free up some room; then I tried a big ass crow bar against it. Didn't budge. Not one bit. It's like there's something else holding it on. I got all 5 bolts out, so all there is left is the alignment pins; took the driver's axle assembly off, took the driveshaft out, and took the downpipe off. Is there something else I'm missing? I seem to have done everything, but it just won't come off. It will move a little off the transmission, but won't go any farther than about 2mm. Any help is greatly appreciated.

 

[PropXprt]

If you have all of the bolts out I am willing to bet that the splined shaft that comes out of the tranny is probably a little rusty (mine was) and this makes a total pain to get off. Just keep trying.