sirboostalot
Probationary Member
- 9
- 0
- Oct 3, 2004
-
oxford,
Michigan
sorry if this has already been asked but i didnt have time to search the fourm. so here it goes about three weeks ago i blew my head gasket so i changed it and it ran fine but i think i didnt tighten the timing belt enough and it slipped and then it didnt run right after that so i figured i belt some valves so i bought a head from a friend for $80 and, so i took my stock cams and put it in the head i just got and now i dont have any compreeion i the first cylinder i havent checked the others yet but i am asumeing that they are the same because when i try to start it all i hear it the starter motor and all the cam gears move but it wont do anything, could i have tighten the cam down to much or to little, i dont know thats all i can think off, or is the new head i got also bad?
