TMO Stage 3 ECU on Galant VR-4

[scottr126]

Hey whats up I just finsished installing a TMO chip on my 91 Galant VR-4. Everything works fine but the only problem is that I cant choose my rev limiters or gauges because the boost gauge isnt reading since it has the digital boost gauge. Any one have any ideas on how I could figure out how to select the gauges and the rev limiters?

 

[4u2chase]

the vr4 has a factory digital boost or your talking about a aftermarket gauge

 

[scottr126]

Yah it is a digital BAR gauge it doesnt read in numbers it has like 6 bars that move up and down.

Scott

 

[steve]

You might want to ask on the GVR4 site http://www.galantvr4.com/ubb/ultimatebb.php but as far as I know the ECU circuitry is the same between the GVR4 and a DSM just the way the signal is displayed. Is it not showing up or is it just that you can't run throught the procedure because of a bad idle position switch?

Steve