injectore o-ring size

d_money1 · 05-09-2008, 09:24 AM

i picked up a set of injector o-rings from a kragen here in town, as i didn't order them when i ordered the insulators, i was wondering if anyone could give me the correct size of the orings, because the ones in the kit did not seal and i need to throw this thing back together for a trip up to my family's place tonight. Thanks for any help!
Neil

DJYoshaBYD · 05-09-2008, 09:35 AM

Dont go there.. Go to a hardware store or something like that.. they will more than likely have a bigger selection of sizes and thickness of o ring.. also, a lil oil around the o ring during install makes the seat easier and doesnt distort them..

d_money1 · 05-09-2008, 01:31 PM

i had decided to take a look back through my Haynes and noticed they say to replace the grommet too, i didn't see much of a need...any thoughts on that?

d_money1 · 05-09-2008, 03:28 PM

if anyone's interested the original part # MD614813 superseded to 1465A188. Steve at San Rafael Mitsubishi was a great help, was callin' him all day and he was very helpful, never got real frustrated or pissed off (i would have been sick of it, for sure!).

DSMunknown · 05-09-2008, 03:33 PM

1G/2G Cheaper Fuel Injector Insulators

d_money1 · 05-09-2008, 04:22 PM

thanks, but i have the insulators, it was the orings i needed. the insulators are only 4 bucks and change from the dealership.