Balance Shaft Bearing

[EVIL EAGLE RT]

Ok so i was messing with my engine last nite and i am trying to remove my balance shaft bearing and they wont budge. any suggestions on how to get em out???

 

[cruisintalonawd]

Go buy the puller it make everything so much easier....even when putting them in

 

[silver bullit]

Are you rebuilding the motor, or just inspecting them? Oh is this the front or back? Where you trying to pull/pry them out? Is the motor out of the car or in?

 

[turbodsm_125]

slide hammer with the puller attached works pretty good. just be careful to only pull on the bearings and not the block. are you putting in new bearings or a bsek? also is the motor in the car or on a stand?

 

[Burnett03]

Large socket and a hammer does it for me

 

[EVIL EAGLE RT]

hey thanks, its out of the car but when i hot tanked the block the bearings like corroded. im replacing them all. where can i find a puller at?

 

[cruisintalonawd]

napa most likely

 

[EVIL EAGLE RT]

if anyone finds one at a store or something on here could you post a link to it, im having a hard time finding one