Igniton wires for cyclone engine

[blazin_talon]

hey guys. i need to replace my ignition wires on my cyclone engine. now ive seen only one thread regarding this issue but it says to make your own wires or just reposition the coil. im pretty sure theres a set of wires out there that can work. does anyone know?

 

[Scientist]

visit the parts store with your current leads....measure them vs the new ones they have.

Or mesure them against the other 1G leads. I will check later whether my cyclone leads are the same as the 1Gs

 

[blazin_talon]

i compared the ones i have with the stock 1g wires. mine are longer. remember the cyclone engine comes with the coil pack bolted almost to the rear lower mani.

 

[Scientist]

yeah i know...my car is a JDM VR4. But i got my leads from the dealership in the caribbean

 

[Marcus92]

I would check to see but my car is under like 20 feet of snow and I'm over an hour away. I'll try to get ahold of the guy I purchased my car from and ask him about it if you cannot get an answer from anyone else on here.