Greddy TT and aftermarket alarm

[my98GST]

Well since the DSM has been down so long, I've finally decided to redo some stuff...

After I got my Viper Alarm, I got my Greddy TT. I cannot lock the doors with my remote until after the car shuts off... Does anyone know how I can lock it while the car is still running?


I think I read some where that there is a yellow wire or something that I'm supposed to tap another wire in to?????

 

[BoostedTalonTS]

It's the Grey wire that is on the GReddy TT... wire it up to a relay like this:

85 - grey wire (TT)
86 & 87A - ignition sense wire (+12 volts when the ignition is on)
30 - alarm's ignition sense wire input
87 - no connection

This way, you will ba able to arm your car and walk away, while in TT mode. Further, it will also keep all existing sensors active while in TT + armed mode, thus you might need to adjust your impact sensor(s) accordingly... Especially if you have polyurethane motor mounts

 

[my98GST]

It's the Grey wire that is on the GReddy TT... wire it up to a relay like this:

85 - grey wire (TT)
86 & 87A - ignition sense wire (+12 volts when the ignition is on)
30 - alarm's ignition sense wire input
87 - no connection

This way, you will ba able to arm your car and walk away, while in TT mode. Further, it will also keep all existing sensors active while in TT + armed mode, thus you might need to adjust your impact sensor(s) accordingly... Especially if you have polyurethane motor mounts

Wait, I'm confused... Are you talking about the wiring harness goign to ECU or are you talking about on the TT harness?

 

[BoostedTalonTS]

neither actually... this can be done right at the alarm harness