getusum
15+ Year Contributor
- 116
- 24
- Jul 23, 2006
-
birmingham,
Alabama
I bouhgt a chip from dsmchips and im not sure im putting it in right. Has anyone installed one before? I matched the groves up and I had to bend the tads a little but after pushing it a=down there is still a little gap between the bottom of the chip and the socket. It feels like it is far as it goes but i dont know. Is it supposed to go all the way down?

I gaot my block O-ringed and new mahnle pistons, and rods. My friend makes 720 awhp on his set up and all he uses is maft,saf, and dsmchips.
