fmic piping, what bends?

[brisk42]

Well i just bought a buschar fmic with the lower piping but no upper. So i was looking to just buy some piping, couplings, and clamps, seperately to make the upper portion. I just need to know what bends and coupling i will need, any help is appreciated

 

[Slow 95 TSI]

I am not sure what a buschar fmic core looks like but if you can make your upper pipe a short route. Mine is a 2g but a 1g should be similar. The same principal the shortest route from the FMIC to the throttle body is best.

Here is the pipes I needed to make mine short route. They are circled They are 2 1/2'' pipes. For the couplings you can buy truck water hose at your local parts store.

You must be logged in to view this image or video.

You will have to cut a small piece out of your radiator support. That is circled in this pic. IMPORTANT: You wire harness runs in this area too, be sure not to cut it.

You must be logged in to view this image or video.

This is what the piece you cut out should look like.

You must be logged in to view this image or video.

The short route gives you a cooler intake charge. It is pretty much a straight from your FMIC to your TB