Need some wire id

[JeanDSM]

Hi
Im tomorow i will be installing a Microtech EMS Fuel and Timing contorler to a friends 2G GST I really dont have the time to search on the forum but if you can help me ill apreciate it.

I need you to color ID the ires of the plugs that i need.

TPS
...signal
...+5V
...GND

Oxigen Sensor
...Signal

1G CAS
...the 4 wires

 

[absolute_DSM]

This may get you closer

http://www.vfaq.com/mods/ecu-harness-2G.html

 

[JeanDSM]

I dont really need the stock ECU pinout becuase MicroTech delivers a new wiring harness loom, all i need it to conect the harnes to the stock plugs like tps CAS injecotrs etc..

I will be doing a write up on this

 

[absolute_DSM]

So if you have the stock plugs why do you need to wire anything?


If you do, isnt it easier to wire it down by the ECU instead of running wires to the engine bay?

 

[GVR4592]

He's connecting the Microtech universal harness to the factory sensor's connectors, there's really no other way to do i if you're using factory sensors.

If you haven't already removed the wiring and sensors from the car, you can just grab a multimeter and figure out which wires are which, it would only take a couple of minutes.