Injector size for GT35R?

[mitsumissile]

My friend is going to get GT35R for his stroke 2.4L. He is going to put down 500HP+ on pump gas. Can anyone give him some suggestion on injector size? 750, 850 or bigger? Thanks

 

[vaboys2ndgen]

1000cc should be more than enough.

 

[SlickGSX]

PTE 880's or 1000cc, you will need more than a SAFC to run them properly though.

 

[mitsumissile]

He is using HKS F-conV Pro to tune it. It's like AEM EMS.

 

[vaboys2ndgen]

i dont know how true it is but i read(i'll have to find the link) that PTE 1000s flow like 950cc..

FIC 1000s flow 1000cc...

i may be off a little bit.

 

[drewvr4]

anything above 850's i would say would be enough.

 

[1whitegsx]

I also read that pte 1000cc injectors actually only flow like 940cc

 

[95blackGsTurbo]

He will need 1000cc if he plans to try and make that power on pump gas. If he has all these mods and a fancy HKS stand alone he should be able to figure out what he needs for injectors I would think?

 

[94Jettameowpsst]

1000's at the very minimum, 1200s if you're running the 3586

 

[DSM_PWR]

For Pump/Race Gas
850cc is more than enough

750cc can support 500hp no problem (seen the dyno's)

But its always best to go bigger if you plan to upgrade later so you wont have to buy again...

if not.. then bigger isnt always better..

For e85
I would get 1600cc because even at 400hp, 1000cc IDC can reach 100% IDC



EDIT: Just looked and this is an old thread