Resolved 1G ISC, idle control motor install help

[highvan]

Ok, The ISC that i ordered just came in, any info or tips on putting it in would be great. Thanks, B

 

[steve]

Get a new o-ring, put it into the throttle body and install the ISC. Reset the ECU and set the BISS.

Steve

 

[MyBeatGSX]

Don't over tighten the screws, you'll crack the plastic.

 

[emd645e3]

When I put mine on, I took the battery out for a little more clearance. I think it helped. I did it once with the battery in and it was a little bit harder.

 

[highvan]

How do i ECU and set the BISS?

 

[Auto RS T]

Here is a link where you can find how to properly set the biss screw.

http://vfaq.com/index-main.html

Here is a link that I did a search on this forum for. I used the words "Resetting, Ecu" in titles only. It gave me the answer.

http://www.dsmtuners.com/forums/showthread.php?t=221523&highlight=resetting+ecu

 

[steve]

How do i ECU and set the BISS?

You missing a verb or two.

To set the BISS: (on 1Gs)
Warm the car up to operational temp. Stop the car.
Ground the timing adjust terminal and pin 10 on the DLC. Start the car.
Adjust the BISS to make the car idle at 750 RPM. Stop the car.
Disconnect the jumpers and your done.

Steve