1g wire harness

[talontsi81]

i was wondering if anyone knew were i could find a 1g wire harness or if anyone knew about them

 

[redrockergsx]

I know about them what you need to know

 

[talontsi81]

I was told u can use a non turbo harness and u just have to had 4 wires do u know if this is true?

 

[redrockergsx]

as long as it was a 2.0 harness it will be the same

 

[9!'clipseDOHC]

I was told u can use a non turbo harness and u just have to had 4 wires do u know if this is true?

Yes you can use a 2.0 4G63 non-turbo wire harness but you will have to add the following wires:

The 7th wire from the MAS to pin #6 on the ECU.

Knock Sensor wire to pin #9 on the ECU. Ground the other wire.

Wastegate Solenoid wire to pin #105 on the ECU. Ground the other one. (If you are using a MBC you can skip this one.)

Also wires for the Injector Resister Pack. Here is a link to a tech article on wiring the injector resister pack.

Also these links will come in handy if you decide to tackle this project: Color coded ECU pinouts and 1G ECU pinouts.

If this looks like a project that you would rather not take on, keep an eye out on the classifieds, junkyards, ebay, and craigslist and you may get lucky and find a factory turbo harness.

Hope this helps!