Front Mount Install Question.

[phatTSi]

Well i just bought a Buschur street front mount and i'm wondering how you run the drivers side piping? I know you run it through the hole in the front on the rad support but the power steering cooler lines run throught it also and the piping wont fit. What did others do about this?

 

[evotuner]

What's up man, this is Allen (Derek's relation, kinda). Anyway to answer your question, I used a sawzall (reciprocating saw) and opened up the hole that you are talking about. It is a pain in the rear, but that is how I did it. Make sure you don't cut into any of the lines for the a/c (or whatever lines you have running through there). Everything will eventually fit, you just have to work at it. On my endtank on the drivers side (I have a slowboy fmic) I had to cut off about 2" so it wouldn't hit my alternator.
Hope this helps!

 

[phatTSi]

Hey Allen thanks for the reply. I knew i was going to have to trim quite a bit but it didn't look like there was going to be enough roon to fit the piping and the power steeling lines. I'll give it a shot. Again thanks for the reply.