2g Gauge Cluster, help plz..

[Spidey]

K, I've searched everywhere and I can't seem to find any info, I also posted in an on-going old thread but I guess nobody noticed, so I'm asking again. I just bought my GS-T a week ago today, so naturally I'm still learning about everything, but here's my question: How do you remove the plexi/black plastic in front of the cluster? Is it only the 2 top screws? I removed the 2 screws and tried pulling it out to no avail, but I didn't pull too hard in fear of breaking something. Any help is appreciated...

Thanks,
Spidey

 

[eclipsegs96]

it will help you out a little buy pulling off the top of the sterring box, that is 2 screws i beleive, then just take out the 2 screws you metioned and she should come right out, very easy.

 

[dave99gst]

i think i reply'd to this allready - i think there is 4 screws 2 on top 2 on the bottom, these allow you to remove the entire cluster , then the clear plexi is attached to the cluster with tabs all the way around it. even with all the screws out it will take some effort the first time you pull it out because there are 2 large plugs behind it that you will be unplugging as you pull it. i hope that was enough info for ya

 

[Spidey]

Thanks a lot guys, much appreciated, got it out today finally and fixed my sagging gauge trim so I can finally see my turn signal flashers and everything else.

Thanks again,
Spidey