What pistons to use for the 420a?

[autoBAHN]

Where would I get some je pistons for my 420a? I tried ebay but can't find any. Is there an alternative I can use? I'm leaking oil burning alot of smoke so I need to prep this car for turbo and make it running new again. Let me know guys!

Also what else should I replace for optimal performance?

 

[GSGoinFast]

http://www.howellautomotive.com/Howell/Store/catalog/catalog/default.php?cPath=142_38_84

if your turboing, and already taking it apart for pistons, why not get some new rods so you can run higher boost. check there, also check the engine kits section if you got the $$ to get a kit.

 

[autoBAHN]

There's quite a few pistons there, which one would be optimal to choose? I already got a set of Eagle rods so that's one thing.

 

[GSGoinFast]

There's quite a few pistons there, which one would be optimal to choose? I already got a set of Eagle rods so that's one thing.

well if your are for sure going turbo and want to run some reasonably high boost, go with the 8.6 compression. but, you will lose some power unitll you turbo. but if a turbo is a ways away, you may want to go with 10.5 compression. give you a little power before the turbo, and can be used with the turbo, although boost must be kept lower and its a lot harder to tune

 

[billy mack]

i used the je pistons, and the burnt easy//
then i went with weisco and theyy are strong still

 

[aliczander]

http://www.howellautomotive.com/Howell/Store/catalog/catalog/default.php?cPath=142_38_84

if your turboing, and already taking it apart for pistons, why not get some new rods so you can run higher boost. check there, also check the engine kits section if you got the $$ to get a kit.

i like howell myself but if all you need are pistons you can get je's here for pretty reasonable http://turboimport.com/catalog/eclipse.htm

 

[miamieclipse]

unless i was mistaken i thought i only saw pistons for the 4g63 there (and rods) hold on let me check again













....










still checking....











Yup i was right

 

[aliczander]

my bad just tryin to help a brother out, ummm let me look in my archives.....
mabe this one will help...
http://www.modernperformance.com/dcx/oneclipse.shtml

just tryin to spread the knolage
aliczander