What lb/min are you flowing on pump & bigger turbos

[daren_p]

15* peak timing [brutal, it plateau'd at 6k], a little knock on top of 3rd; my aem uego says I was running 11.6 afr but I think it's incorrect; projected a/f was at 10.8 across the rpm range.

Time for meth injection

 

[90blacktsiawd]

New set up is in so it's time to report in again

2.3l
unhacked 2g mas
ported 2g head w/ 1mm OS valves
cyclone that is running all 8 runners all the time right now
272's
3076r

52.7 lbs/min @ 24 psi. It was about 35 degrees out as well.

 

[danyz250f]

50 lbs/min not very good tune but calibrated maft with dsmlink and pte 6031 (60-1)

daily 41 lbs/min on ~17psi~

I wanted 50 now I want 60. The sickness gets worse....

Isnt a good horsepower calculation times your lbs/min by 9 and that gives a close hp number?

 

[RipperXX]

I did find a boost leak, and was and still am pretty much uncalibrated. Soo yea my air flow #'s were most likely a little off.

I got tired of trying to get the LTFT and STFT close and gave up. Made a small correction and left it alone. I need someone to tune my car for me .

 

[niki_talon]

1g talon auto 69lb/min gas 95oct. turbo hta37 36psi. I think it's enough for street

 

[JusMX141]

1g talon auto 69lb/min gas 95oct. turbo hta37 36psi. I think it's enough for street

The last post in this thread was made over 11 years ago, some 6 months after you joined the site. Back then running 18psi on a 50-trim was pretty daring, and getting anywhere near 70 lb/min on pump gas was impossible due to tuning limitations.

Pay attention to thread dates

 

[niki_talon]

Yes the future is here !