[96gsdsm]

Before I start off here I'd like to say my mods are all up to date.

I've been trying to run my meth controller (snow perf. MAF signal kit) off my GM MAS... but the signal (yellow wire) seems to be way too strong. I have both dials on the controller set to as high voltage as it goes (.5v I believe) ... Idle air is like .4v.

The meth is turning on WAY to earily and I'm running out of ideas as to where to tap into a .0 to +.5v airflow signal. At 2k rpms the controller goes to full on and it bogs like mad. It's ridiculous.

What do those of you running similar set-ups have your signal wire tapped into?

Thx. in advance.